This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
roma [2020/09/23 18:41] team |
roma [2020/12/06 11:21] team |
||
---|---|---|---|
Line 16: | Line 16: | ||
It is possible that on startup you will have an error like "Unable to contact wicd daemon dbus access denied". | It is possible that on startup you will have an error like "Unable to contact wicd daemon dbus access denied". | ||
This is because your user has not been added to netdev group. | This is because your user has not been added to netdev group. | ||
- | We also installed network-manager alongside wicd that still gives the possibility to start wifi connections, both wpa and wpa2. | + | We also installed network-manager alongside wicd that gives the possibility to start wifi connections, both wpa and wpa2. |
If you still prefer to use wicd, start a terminal and type the following commands: | If you still prefer to use wicd, start a terminal and type the following commands: | ||
- | <code>sudo adduser //youruser// netdev</code> | + | <code>sudo adduser youruser netdev</code> |
+ | where //youruser// is your user chosen during system installation and then: | ||
<code>sudo /etc/init.d/dbus reload</code> | <code>sudo /etc/init.d/dbus reload</code> | ||
- | where //youruser// is your user chosen during system installation. | + | |
+ | ===== How to install Ufficiozero-patches-dummy ===== | ||
+ | |||
+ | We have created a package through which to apply some patches so if you have problems installing third-party drivers, all you have to do is update your system using synaptic and select replace when required to modify sources.list file. | ||
+ | Here below some screenshots: | ||
+ | {{ :update-1.jpg?nolink&600 |}} | ||
+ | {{ :update-2.jpg?nolink&600 |}} | ||
+ | {{ :update-3.jpg?nolink&600 |}} | ||
+ |